Jump to content

Log in or register to remove this advert

Rate My Hinge.


Frank
 Share

Recommended Posts

Tim, a nice clean hinge, but out of curiosity why did you cut the feathers off one side?

 

Never really understood why people cut off the most important part of the hinge?

 

It was trimmed up so the bar clears the width in one hit , the buttress of a tree can splay out and cause the bar the fall short on the other side , a way around this is to cut heigh .

Link to comment
Share on other sites

Log in or register to remove this advert

Yeh, I understand that Tim, but, the whole idea of a hinge is to give direction of fell. The wider the hinge, the more stability and control of direction.

 

Cutting buttresses, or "feathers" purely to fit the bar length, jeopardises the effectiveness of the hinge, especially if there is lean, decay or even wind.

 

A much better use of the hinge is to leave it as wide as possible, and either get a bigger saw, or cut from both sides.

Link to comment
Share on other sites

Ive seen buttress roots get ripped out of the ground coz the tree wasn't buttressed. Would of hurt the cutter is he didn't move.

 

Yeh, seen it too but usually when the face closes. By the time the face closes, there's a pretty good chance the stick has fallen in the required direction.

 

On the occasion the buttresses tear out before the face close, it's more likely the stick would of been even further off target, had they been cut back first. They WILL of helped keeping direction before ripping out.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share


  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.