Rear handle fixed harness attachments

[Dan Maynard]

I just use biner, and the ring on saw strop. Ringing down a stem I don't pull it up and down very often so this doesn't upset me.

 

Saw the ring, feather throttle to keep cutting in through in one. Leave that log where it is, saw half way to next ring and leave the saw there. Now push off top ring, step down on stem, move lanyard so you have room for another cut. Repeat.

[Mark Bolam]

Well you can do that because each time you step down there’s another 7’ log to chuck off.

[Rich Rule]

Just get an old tool strip.  The end with the ring for high attachment and cut off the bungee bit.

 

Girth hitch it to the handle and you have a ring to hang on your carry tool.

 

Personally I just use a large Bina in my tool strop.  It fits the handles of rear handled saws and I clip it to my harness with that.

 

Same as this video but obviously that isn’t a rear handled saws.

 

 

 

 

[Rich Rule]

 

[Mark Bolam]

19 hours ago, Mick Dempsey said:

There’s a rubber thingy that will hold a Krab rigid in a rear handle, I’ll see if I can find it on the net..

Like this Mick?

Stein rubber retainers.

 

[Mark Bolam]

They are about a quid each.

 

[Mark Bolam]

Josh you owe me £1.

I just snapped one taking it off my saw after doing that demo for you.

[Mick Dempsey]

1 hour ago, Mark Bolam said:

They are about a quid each.

 

No, but that looks the business..

[Ledburyjosh]

3 hours ago, Mark Bolam said:

Like this Mick?

Stein rubber retainers.

 

This is the one. Thanks

[Ledburyjosh]

3 hours ago, Mark Bolam said:

Josh you owe me £1.

I just snapped one taking it off my saw after doing that demo for you.

Apologies.

 

Bike inner tubes work well for this. cut a section out and with a twist it holds it in place. I'll post a picture later