cable brace advice

[Dan Maynard]

I think the idea of using an impact driver as a way of managing the reaction torque is novel. To me it does have the whiff of snake oil about it, if you could suddenly increase cutting tool performance and life by a factor of two then people like Dormer and Sandvik would be all over it. After all cutting tools have been thought about a lot, by a lot of people.

 

I suspect they are twice as good as cheap tat, and more equivalent to the decent ones that few people buy.

[dumper]

Just try one they are not cheap but a lot of steel fixers use them no pilot holes and drill straight through 20mm thick steel you need high powered impact 1/2 or 3/4 drive and plenty of cutting grease it’s a easy tool to use especially up in a cheery picker I’d link a video but haven’t a clue how to