Jump to content

Log in or register to remove this advert

Leylandi tips turning brown after cut


Recommended Posts

Hello,

 

Wishing you all are well.

 

I wondered if someone with experience had an insight into this:

 

I cut a leylandii cypress hedge early May after i guessef frosts were over (east anglia, uk), and made sure to leave a good 5-6 inches minimum of green foliage when I cut, and cut back to the same place roughly as last year.

 

The hedge overall appears in fine, but is peppered with 'brown tips' at the site of each cut, about a few mm deep at each place.

 

My intial thoughts and guesses were that, maybe my hedge cutter isn't powerful enough (greenworks 40v) for a clean cut and 'chewed' the hedge a bit, or the blades aren't as sharp as last year and my home sharping not up to par.

 

Or is early May still too cold? (Leylandii.com recommended pruning once a year in spring or summer).

 

Thank you in advance for any replies.

 

(Attached pics)

 

Regards

 

 

20240522_091857.jpg

20240522_091905.jpg

Link to comment
Share on other sites

Log in or register to remove this advert

I wouldn’t worry, looks like you’ve gone in quite tight, so you’ll get a few brown bits.

Leylandii can’t be kept at a constant width, they have to get a little bigger every year, till someone goes in too hard and the big brown patches appear.

  • Like 2
Link to comment
Share on other sites

Ah- thank you so much!

 

So each year they have to get an inch or so bigger.

 

Thats the difference between reading a website with no experience "cut back to the same point each year" and with experience knowing 'how' to read that ("cut back to the same point-ish i.e slightly less each year").

 

 

 

 

Link to comment
Share on other sites

In that second photo, the close up, the brown bits haven't been cut, they might possibly have been chewed at by a blunt trimmer. Id have happily trimmed that a bit tighter than you have. But I wouldn't worry it will grow out again all to quickly!

  • Like 1
Link to comment
Share on other sites

Went through something like this a few years ago with a hedge trimmer that you could not tighten the blades ( shoulder bolts through the blades) the blades then tear the the non woody spindly parts of the hedge rather than clean cut it.

  • Like 1
Link to comment
Share on other sites

11 hours ago, shillo said:

In that second photo, the close up, the brown bits haven't been cut, they might possibly have been chewed at by a blunt trimmer. Id have happily trimmed that a bit tighter than you have. But I wouldn't worry it will grow out again all to quickly!

The tips will turn brown sometimes no matter how sharp cutter is, had it on a hedge a couple of years ago hedge cutter was brand new and razor sharp. 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.