Woodworking advice needed for fixing wheels

[Steve Bullman]

Project is a sweet cart style piece for our shop. Will be similar sort of thing to the one in the image attached. I’ve sourced a couple of wheels but can’t decide how to mount them for the best. Would be nice if they turned but it’s not crucial. Any suggestions please?

 

 

[Stubby]

3 minutes ago, Steve Bullman said:

Project is a sweet cart style piece for our shop. Will be similar sort of thing to the one in the image attached. I’ve sourced a couple of wheels but can’t decide how to mount them for the best. Would be nice if they turned but it’s not crucial. Any suggestions please?

 

 

An axle right through from one side to the other threaded each end and a nut and washer either side . 

[GWYNFIL]

large  wooden curtain pole or scaff pole pin either side . hole saw a bock if too small. might wobble at bit at 40 mph though lol

[Steve Bullman]

1 minute ago, GWYNFIL said:

hole saw a bock if too small.

What does this mean please?

[Steve Bullman]

The hole on the wheels is pretty big, probably 4”

[Stubby]

Just now, Steve Bullman said:

What does this mean please?

Its genuine frontier gibberish Steve ......🙂

[GWYNFIL]

jigsaw a plank? piece round 4"  circle then drill it to suit axle

 

Edited October 19, 2023 by GWYNFIL

[GWYNFIL]

10 minutes ago, Steve Bullman said:

What does this mean please?

block! had a shandy

[GWYNFIL]

11 minutes ago, Stubby said:

Its genuine frontier gibberish Steve ......🙂

il have u know i have a woodland mills not a frontier mill lol

[daveatdave]