Oak for milling

[Al Cormack]

Pulled out 3 decent oak trunks from the pile. Any good for anyone in Surrey / Berkshire area?

 

Lorry bed is 16 ft. Diameters are 24inch and 2 x 18 inch

 

 

 

 

 

[Rough Hewn]

The two on the right look good for milling, not sure about the left one. Might have rot.
Wish I was closer, I'd have them off you.
Good stuff.
[emoji106][emoji106][emoji106]

[mr kipling]

Hi how much are they and could you deliver to East Sussex? If not I may be able to sort transport 

[Squaredy]

8 hours ago, Al Cormack said:

 

Pulled out 3 decent oak trunks from the pile. Any good for anyone in Surrey / Berkshire area?

 

Lorry bed is 16 ft. Diameters are 24inch and 2 x 18 inch

 

 

 

 

 

 

Nice truck....wish someone had a vehicle like that near me....  Timber lorries are just too big sometimes.

[Al Cormack]

Hi how much are they and could you deliver to East Sussex? If not I may be able to sort transport 

I was thinking £150 but couple of millers have said more like £80. I'd make more logging them up, but seems a shame to to do that.
They are in West End near Chobham so I think transport to East Sussex would kill it. If I was delivering would be looking at about £280 + vat.

[HuntingHicap]

Two ifor williams loads? Could I collect?

[mr kipling]

Hi, could you call me on 07967123747 cheers Chris 

[Al Cormack]

Two ifor williams loads? Could I collect?

Weight wise I reckon it would be one load, just a question of how long your trailer is.

[HuntingHicap]

I have a 14', how long are the two smaller butts? if they are a bit shorter and could be pushed up to the front should balance the bigger bit over hanging the back slightly?

[Al Cormack]

I have a 14', how long are the two smaller butts? if they are a bit shorter and could be pushed up to the front should balance the bigger bit over hanging the back slightly?

Measured them properly now. 2 are about 11ft and the longest is just under 14ft.
Where would you be coming from?