Stenner 48

[Graham w]

Loading isn't to much of an issue as we have a job loadall but rolling them while on the table could be fun at chest hight! I suppose I could make a gantry to walk on?

 

that could be a no go area. i wouldnt want the bench any higher than waist height with plenty room to step back (escape route) should anything roll towards you. remember when you have taken your first cut the balance leans to your side

[AdamnRalph]

that could be a no go area. i wouldnt want the bench any higher than waist height with plenty room to step back (escape route) should anything roll towards you. remember when you have taken your first cut the balance leans to your side

 

I'm glad you had thought of that cos I hadn't! I've only ever used a horizontal bandsaw.

[billy_wizz]

Sod it rolling towards you had 10 inch bars thrown all over the place on a particularly springy load of larch luckily most of it was on the side furthest away from the operating lever!

[rich crowther]

Yea iv got an original data book kicking around somewhere shows every detail you need il dig it out

 

 

Sent from my iPhone using Arbtalk

[AdamnRalph]

Yea iv got an original data book kicking around somewhere shows every detail you need il dig it out

 

 

Sent from my iPhone using Arbtalk

 

That would be great! I'd buy it off you if it was for sale?

[rich crowther]

Hi sorry the manuals actually for the stenner mobile bandmill not the static model as I thought

 

 

Sent from my iPad using Arbtalk

[Ollie]

Hi there I've got hold of the plans. They're for a VB 42 not a 48 though. Can scan and email to you if any use?

 

Sent from my SM-G900F using Arbtalk mobile app

[Ollie]

 

Sent from my SM-G900F using Arbtalk mobile app

[se7enthdevil]

every yard should have one of those...

[Graham w]

every yard should have one of those...

 

every yard had one!