Saw repair in Coventry area

[Lunner]

Is there anyone in the Coventry area, or just south of that could have a look at setting the carb on a Sthil Ms211 for me. I've got it running on Aspen as it only has occasional use, and just want to make everything is set up as it should be

 

Sent from my D6603 using Tapatalk

[clearview]

Hi, try tudor environmental in Canley a try. I have used them on my 261.

[Joe Newton]

2nd Tudor

 

Wayne is your man for anything 2 Stroke

[peatff]

Is there anyone in the Coventry area, or just south of that could have a look at setting the carb on a Sthil Ms211 for me. I've got it running on Aspen as it only has occasional use, and just want to make everything is set up as it should be

 

Sent from my D6603 using Tapatalk

 

Does it run different on the Aspen ? My Husqvarna 135 took about an eighth of a turn in on the L screw and it's been fine. Warm it up and see what happens it might not even need adjusting.

[Lunner]

Thanks guys.

 

I had a few problems with it running then stalling from cold, so had a bit of a mess around with it myself. Got it running ok now, but just want to check what I've done isn't gonna kill it over time

 

Sent from my D6603 using Tapatalk

[peatff]

Thanks guys.

 

I had a few problems with it running then stalling from cold, so had a bit of a mess around with it myself. Got it running ok now, but just want to check what I've done isn't gonna kill it over time

 

Sent from my D6603 using Tapatalk

 

Has it got limiters on the carb adjustment screws ? If it has you will not move it far enough to do any damage. The only problem would be if you screwed the H screw in and leaned it off enough to seize it but that is unlikely.

[Lunner]

The screws will only turn one full turn. Saw is about 9 months old, and has only had about a gallon of fuel through it

 

Sent from my D6603 using Tapatalk

[Eddie@aspen]

Hi,

 

Any questions on tuning see our dealer map and look for the "Aspen Service Centres" These dealers are using Aspen in everything and so will be able to help.

 

You can always call me on 07568108953

 

We are here to help

 

All the best Eddie

[Davy]

I have a workshop in Warwick and could sort it for you

 

Dave

01926 497094

07768 231781