husqvarna 372 xp xtorq

[adw]

The biggest issue is locating the spring for the throttle lock correctly, if it is not in the correct position it will restrict the trigger opening, very difficult to explain where it should be.

[forest tink]

The biggest issue is locating the spring for the throttle lock correctly, if it is not in the correct position it will restrict the trigger opening, very difficult to explain where it should be.

 

I know what you mean,but I reckon when I get it all attached it is good to go,both parts of the outer sleeve are secure with the cable moving freely until I fit it on the carb

[adw]

Give me an e mail address and i will send you the shop manual

[Eddy_t]

If it's the non x-torq version, have you put it into the little white arm on the plastic bit the carb screws onto?

 

 

Sent from my iPhone using Arbtalk

[forest tink]

it is the xtorq version,iv never had any bother in the past with these,only this saw

[Eddy_t]

Oh, it's a black plastic arm then

 

 

Sent from my iPhone using Arbtalk

[wisecobandit]

I would check to see if the arm part numbers are the same.

It maybe the same handle/tank but remember it is a different carb between non xtorq and the x torq versions and they are different.......

[Eddy_t]

I would check to see if the arm part numbers are the same.

It maybe the same handle/tank but remember it is a different carb between non xtorq and the x torq versions and they are different.......

 

 

The arm numbers are different, the 372xp (old) has a horizontal carb mount, the x-torq has a diagonal mount like the 385/390xp

 

 

Sent from my iPhone using Arbtalk

[forest tink]

right enough it is different,have to say im not overly impressed with the saw,im using a 576 just now and its miles better

[Eddy_t]

right enough it is different,have to say im not overly impressed with the saw,im using a 576 just now and its miles better

 

 

I'll put a pic up for you in a few days time (hopefully) of how the linkage should be routed, as I'm modding my 362xp, so I will be setting up the same linkage

 

 

Sent from my iPhone using Arbtalk