Macrocarpa milling - timber properties and uses

[Big Beech]

1 hour ago, trigger_andy said:

Do you have the quick release handles for the legs? Makes adjusting much quicker. You're done within 90 seconds. 

I have the old system, and I am not prepared at this stage to shell out for the cost of the new brackets and quick release unit.

If they where backwards compatible it may be an option, but they don't look to be or read that way on the description.

[trigger_andy]

18 hours ago, Big Beech said:

I have the old system, and I am not prepared at this stage to shell out for the cost of the new brackets and quick release unit.

If they where backwards compatible it may be an option, but they don't look to be or read that way on the description.

The kit I got off of Chainsawbars was cheap, basic and backwards compatible. It works with the existing brackets. 

[Big Beech]

32 minutes ago, trigger_andy said:

The kit I got off of Chainsawbars was cheap, basic and backwards compatible. It works with the existing brackets. 

The listing read that it was only for the new end bracket design and was in that statement not backwards compatible ?.

So therefore I bought a whole new spares pack.

Edited September 13, 2020 by Big Beech

[trigger_andy]

9 minutes ago, Big Beech said:

The listing read that it was only for the new end bracket design and was in that statement not backwards compatible ?.

So therefore I bought a whole new spares pack.

Thats the one I bought. Needed a few extra spacers and Rob sent them out for free.

 

I have/had a Chinese Ecomill but one of the Legs is a genuine Granberg. Fits fine and works great. 

[Big Beech]

Typical