How do we not have a chainsaw photo thread?

[Stubby]

Sacrilege doing that to a stihl 😭😱😖

 

Sacrilege doing that to a Husqvarna bar

[wyk]

Sacrilege doing that to a Husqvarna bar

 

And I had to hack that puppy up, too.

[Eddy_t]

Sacrilege doing that to a stihl 😭😱😖

 

 

How is it, the engine, carb and av system is already husky

[Lumberwolf]

You could at least have put an Oregon bar on it 😏

[Eddy_t]

You could at least have put an Oregon bar on it 😏

 

 

He did, it just has a different paint scheme

[Lumberwolf]

He did, it just has a different paint scheme

 

Alright smartarse 😉

[Eddy_t]

Alright smartarse 😉

 

 

Actually, all joking aside, the husky bar will improve the saw! Husky runs a narrower gauge chain, which is lighter and requires less power to run. Arguably he could run a narrow kerf bar and chain, but they're harder to find in the UK, assuming wyk is in Ireland rather than the USA currently.

[mendiplogs]

Actually, all joking aside, the husky bar will improve the saw! Husky runs a narrower gauge chain, which is lighter and requires less power to run. Arguably he could run a narrow kerf bar and chain, but they're harder to find in the UK, assuming wyk is in Ireland rather than the USA currently.

 

HI EDDY hows the power up job going on your 560 mate thanks jon

[wyk]

Actually, all joking aside, the husky bar will improve the saw! Husky runs a narrower gauge chain, which is lighter and requires less power to run. Arguably he could run a narrow kerf bar and chain, but they're harder to find in the UK, assuming wyk is in Ireland rather than the USA currently.

 

That is exactly why that Stihl is wearing that bar. It's an Husqvarna "pixel" bar with Carlton narrow kerf semi chisel chain. Not sure I needed to do it, but I got the B&C for xmas, so I just made it work. The bar is a bit flimsy feeling, so we'll see how she lasts. Here she is ported VS muff modded, semi chisel VS full chisel. 14" bar VS 17"(it ended up at 70DL on 325 after I modded it to fit).

 

[ame]

[/ame] Edited January 22, 2015 by wyk

[Eddy_t]

HI EDDY hows the power up job going on your 560 mate thanks jon

 

 

It's good Jon, but I'm not using the saw much currently, someone at work complained about noise