What PTO chipper/shredder 26hp max?

[Ty Korrigan]

Hello,

Purely speculative purchase for now as our John Deere 1026 arrives Tuesday

We are thinking of matching it with a chipper or shredder if available for woodland working. It would be chipping smaller branches left after firewood has been harvested on private land rather than balls out forestry work.

I know of the Timber wolf and G.M wee chippers but what else is out there for a tractor with 26hp?

Regards

Ty

[tractorboy1]

Hello,

Purely speculative purchase for now as our John Deere 1026 arrives Tuesday

We are thinking of matching it with a chipper or shredder if available for woodland working. It would be chipping smaller branches left after firewood has been harvested on private land rather than balls out forestry work.

I know of the Timber wolf and G.M wee chippers but what else is out there for a tractor with 26hp?

Regards

Ty

 

These look pretty good remember you only get about 80-90% of the power at the pto.

 

http://wallenstein.co.uk/brochure/Wallenstein_20Chipper_20Shredder_20Brochure.pdf

[Timberwolf Official]

Try this.

TW PTO/100G | Products | Timberwolf

[rowan lee]

I have the older version of this Negri, il marchio verde - Biotrituratori - R225 - R225T (The R220T)

 

I run it on an old 35 no worries. 4'' capacity, built-in hydraulic pump for infeed roller, removable blades on drum with shredding hammers for dirty stuff, direct shaft drive with shock absorbers (no V-belts to worry about). I bought it second hand for about a grand, so you can pick them up reasonably cheap. Have run it on an estate for about 3 years now, no problems whatsoever. Great little chipper.

[GlobalNewark]

[ame=http://http://www.youtube.com/watch?v=M8qCtTGq-jA]http://http://www.youtube.com/watch?v=M8qCtTGq-jA[/ame]What about this Ty?

[PeteB]

Hey Stewart, the GreenMech EC150TMP may fit the bill if the CS100 TMP doesn't do it for you.

[TRADITIONAL LOGGERS]

Laimet.

Edited September 21, 2013 by TRADITIONAL LOGGERS
PC Spelling.

[PeteB]

I may well be wrong, but surely a Laimet would heed more than 26? Especially when doing thicker material as they don't have roller infeed but do have corkscrew feed!