Jump to content

Log in or register to remove this advert

Stihl FS80 over-revving


RichardT
 Share

Recommended Posts

Put this back together after a clean, was idling v fast on restart so wound the idle screw down...down...down to the stop, cutting head still spinning at a fair clip.

 

The idle screw is seemingly the only adjustment available on this model - cheapo carb presumably - anything else I can check or is it a new carb?

 

Thx.

Link to comment
Share on other sites

Log in or register to remove this advert

Try manually pushing the throttle arm on the carb shut to see if the throttle mechanism isn't sticking open a little.

 

Some of these cutters have a quadrant the cable runs over peg ore connecting to the carb and it has a t27 screw to take up slack in the cable. Check it isn't holding the throttle open

Link to comment
Share on other sites

Well, the Arbtalk Brains Trust nails it again. Virtual drinks all round.

 

Throttle ass'y looked fine, but looked again and when I'd reseated the brass end cap that locates the cable sleeve on the quadrant, I'd apparently jammed a detached bit of the plastic inner coating in front of it, so it was about 3-4mm short of its stop.

 

Sloppy.:blushing:

 

But not expensive! :001_smile:

Link to comment
Share on other sites

Well, the Arbtalk Brains Trust nails it again. Virtual drinks all round.

 

Throttle ass'y looked fine, but looked again and when I'd reseated the brass end cap that locates the cable sleeve on the quadrant, I'd apparently jammed a detached bit of the plastic inner coating in front of it, so it was about 3-4mm short of its stop.

 

Sloppy.:blushing:

 

But not expensive! :001_smile:

 

Must try harder ! :biggrin:

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

Articles

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.