Poplar That Swollowed The 088

[skyhuck]

fook thats a big pop m8.1st beer would of gone down well after that 1

 

Mike does get some very big trees, and some very interesting jobs, I always look forward to his pic's:001_tt1:

[MasterBlaster]

You must have smaller 088's over there, orrrr something, LOL!

[burrell_]

i cut up a poplar 36 inch at the bowl with a o24 with a 16 inch bar it fell over in the wind i had no problem i will post pic tomorrow if u guys want to see them so that 088 should make lite work off that lol

[skyhuck]

i cut up a poplar 36 inch at the bowl with a o24 with a 16 inch bar it fell over in the wind i had no problem i will post pic tomorrow so that 088 should make lite work off that lol

 

Err :confused1:how:confused1: 16+16= 32 not 36:confused1:

 

Or did you chunk it? which is ok but takes time and makes a lot of wast:thumbdown:

[Dean Lofthouse]

Err :confused1:how:confused1: 16+16= 32 not 36:confused1:

 

Or did you chunk it? which is ok but takes time and makes a lot of wast:thumbdown:

 

Plunge the middle of the gob and take the middle out first

[skyhuck]

Plunge the middle of the gob and take the middle out first

 

Dean READ his post he said CUT UP not fell!! the tree fell over in the wind!!

 

Yes of cause you can fell 2.5 times guild bar, big saws are for ringing up or slabbing down, IMO.

[burrell_]

didnt chunk it just took about 2 inches off either side in a v shape, then cut it form either side did wonder how i was do it. when i looked at the job, for some reason it didnt seem that big when i priced it lol i will posts pic

[burrell_]

Plunge the middle of the gob and take the middle out first

 

it was all ready on the ground no gobs

[Mike Hill]

I bet the 026 was smoking hot after that job mate! Good thing it was a Poplar and not a 36" Oak eh.

[burrell_]

o24 mate less power it cleared the old saw out thats for shore if it was a oak would have got a new saw lol 660