Jump to content

Log in or register to remove this advert

Chainsaw Fuel Tax


TRADITIONAL LOGGERS
 Share

Recommended Posts

i think even if you were successfull, the companies would seek to line their pockets by putting up their prices to compensate for the reduction in duty. When VAT was reduced to 15% did prices fall?I think not!!

 

As the largest cost is the duty the retailer could double the profit (profit not cost so a few pennies per L) & we would still be loads better off.

 

Oh & yes lots of prices did fall.

Link to comment
Share on other sites

  • 2 months later...

Log in or register to remove this advert

  • Replies 25
  • Created
  • Last Reply

Top Posters In This Topic

Anyone into model r/c aeroplanes will know that the small engines employed in them were often "glow-plug" i.e. compression ignition engines so effectively a diesel. If they can work then I wonder why they haven't found their way into garden machinery???

 

Ditto :thumbup1:

 

The UK market is very small compared with non-European markets where -- as I'm sure you all know -- the cost of fuel is often very low (or so it seems to us). North Americans think that diesel is only for trucks -- they are invariably astonished if you tell them as a Brit that your car or even pick-up is diesel. As a consequence the big international manufacturers, historically, have only tended to make gasoline (petrol)-powered equipment. Indeed, I think I'm right in saying that Honda and several other Far-Eastern manufacturers only make petrol-powered quads and lawnmowers for instance, and it's only recently that a few have started to make diesel versions as it's slowly dawned on them that there's a market for them.

 

Another reason diesel tends not to me used for small equipment is that petrol 2 strokes are a lot simpler (hence cheaper) and produce a lot more power for a given weight compared with alternative engines -- which is of course crucial with hand-held equipment.

 

The only reason I can see why a campaign to reduce the tax of alternative fuels for hand-held ag. or arb. equipment might fall on politicians' deaf ears, is that if as a result it becomes cheap, the treasury might be concerned that people will put it in their cars instead of their chainsaws. And the introduction of 'red petrol' might create a whole new tier of cost if it is to be policed.

 

However I wish you luck with the campaign.

 

Best wishes,

 

John Russell

Link to comment
Share on other sites

i'm not into R/C cars or planes but i do know the fuel comes in 5,10 or even 20 litre drums, if its going to be such an issue about people putting the fuel in there cars, then why not try for a 2stroke mix of fuel in the above quantities.

 

great idea and hope it works.:thumbup:

Link to comment
Share on other sites

There have been diesel chainsaws - 1950s I think, made by Comet and later by Jonsered. It was a 2-stroke semi-diesel, with a pre-heat required on the hot bulb. Apparently it worked very well but there was no commercial advantage at the time.

 

One thing that may be helpful on the duty question - canal boats often have diesel heating, cooking and engines. Prior to the introduction of duty on the fuel used in the engine, all were duty-free, so the boats usually only have a single fuel tank. When duty was introduced, the rule came in that you self declare the proportion of the fuel you use for cooking/heating vs. that for the engine, and only pay duty on the latter. This approach could equally be applied to petrol driven agricultural/arboricultural equipment. I think though that the much stronger argument with fuels like Aspen is that it's so much more expensive than pump fuel, and will remain so, that the only reasons for buying it are health or environmental related, and nobody is going to try to buy it as a cheap way to fill up their car! As such, it isn't going to make a dent in the government's coffers - maybe a few tens of £k a year at most?

 

 

 

Alec

Edited by agg221
Link to comment
Share on other sites

When working in Norway I found that the fuel is tax free due to the health concerns of professional chainsaw workers and the forests we work in.

 

Same thing goes for Sweden (no duties), and Sweden is a EU member.

 

To politicians, it is always important pointing out that they are not the first to make a decision.

Link to comment
Share on other sites

Well done for starting this.

 

Is there going to be some kind of online petition form? if so then please forward it to myself and I will pass it on to all of our customers.

 

This is something we are working on but obviously it will work a lot better if its coming from the likes of yourselves and not from us directly.

 

please let me know if you require any further information from us.

 

Kind Regards

Axel Hildebrand

Aspen Fuels

 

Alex,

 

Could you assist by providing a breakdown of the current price of Aspen (and other alkylate) fuels?

 

i.e.

- Cost ex-refinery

- Tax/Duties

- VAT

- Wholesaler markup

- Retailer markup

 

That way, we can all see, what it would mean to the retail price if tax was reduced. 56p/litre reduction would likely reduce the retail price in the order of 100p/litre.

But the increased volumes generated by the lower price would likely make up for any reduction in wholesaler and retailer profits caused by the reduced unit prices.

 

Also, why don't you get in touch with Aspen, Sweden to see if you can get some materials from the political decision making regarding taxation of alcylate petrol, and pass that on to support the UK campaign.

Edited by morten
spelling
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share


  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

Articles

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.