Jump to content

Log in or register to remove this advert

Chainsaw won’t cut on both sides of the bar


Hfbsfc
 Share

Recommended Posts

Log in or register to remove this advert

4 minutes ago, pleasant said:

Spud, I am pretty certain the bar mount for a Stihl bar that takes a 1.6mm gauge chain will be too big for the MS231 and the adjuster pin will not locate either.

You are probably right, it was just a random thought and my own feeling on this one is that it is probably something pretty silly.

Unfortunately I have been here before, someone with a loose bar that wouldn't clamp up. He had measured everything and technically, his measurements and other info proved that what he was experiencing was impossible. After around 6 pages of thread....we found his measurements had been made with the famous elastic measurement device!!! I had walked out after page 39_9

  • Like 1
Link to comment
Share on other sites

Yup.....another I had was a guy was complaining no matter how much he tried, after adjusting the chain...correctly he said, after the first cut the chain would loosen right up. Told him to bring it in which he did, I said 'show me how you tension the chain then' He proceeded to do everything correctly.....until before tightening the cover nuts he didnt take the weight of the power head by the end of the bar, consequently as soon as he was putting any pressure on the bar in first cut, the bar would slip upwards slightly thus slackening off the chain, before having further upward movement halted by underside of the front bar stud in the mount.

 

Showed him how to do it and he never came back with that issue again.

 

Like i said in an earlier post.....it's a lot easier to come to a conclusion after you've seen the machine AND the operator.

Edited by pleasant
  • Like 2
Link to comment
Share on other sites

11 hours ago, Canal Navvy said:

Been wondering what length bar is on the saw, poor thing could be being expected to do the work of one of its bigger brothers. 🤔 

The longest OE bar from stihl that will fit the 231 is the 18" off the 251. Recommended bar length for the 231 is 16" although for occasional use it will cope with the 18" just, even so, it will cut effectively on both upper and lower rails.  The extra 2" wont highlight the issues the OP has.

Edited by pleasant
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share


  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

Articles

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.