357XP advice

[Joe Newton]

3 hours ago, frammo said:

? Why would I do that  and if you aren’t running that on a properly ported 357 why waste your money getting it done ?

here we go with another one...

 

What do you do for a living mate?

[spudulike]

On ‎19‎/‎07‎/‎2020 at 13:47, Joe Newton said:

I think my ported 357 was pulling in excess of 200psi cold when Spud did it. That was a reconditioned cylinder from a previous seizure. 

 

That was a few years ago and it's been worked hard ever since. 

2014 when I ported it, not bad VFM in my book

[Joe Newton]

8 hours ago, spudulike said:

2014 when I ported it, not bad VFM in my book

That long huh! I still get anyone who's used it offer to buy it from me. 

 

Fancy doing another one?

[Tommy_B]

@Joe NewtonGive me a visit if you're popping down!

[Joe Newton]

4 hours ago, Tommy_B said:

@Joe NewtonGive me a visit if you're popping down!

I was gonna mail it but that's not a bad shout!

[Tommy_B]

22 minutes ago, Joe Newton said:

I was gonna mail it but that's not a bad shout!

If you post it, that only takes 30 minutes out your day then you'll get given loads of other jobs to do. Tell Lizzie that you have to hand it over face to face for security reasons and you might be home by 8pm.

Job done. We can sit and eat cakes in the garden

[Joe Newton]

1 hour ago, Tommy_B said:

If you post it, that only takes 30 minutes out your day then you'll get given loads of other jobs to do. Tell Lizzie that you have to hand it over face to face for security reasons and you might be home by 8pm.

Job done. We can sit and eat cakes in the garden

That's solid "escapee dad" logic right there ?

[spudulike]

Cake.........what a life