Jase hutch
-
Posts
1,364 -
Joined
-
Last visited
-
Days Won
1
Content Type
Profiles
Forums
Classifieds
Tip Site Directory
Blogs
Articles
News
Arborist Reviews
Arbtalk Knot Guide
Gallery
Store
Freelancers directory
Everything posted by Jase hutch
-
If turning the tap through 90 degrees makes no difference then I doubt it's the solenoid valve at fault. Take off the pressure hose from the pump at the feedroller control valve and put this into a bucket , run the engine and check the flow of oil into the bucket ? It should be a good continuous flow , free of air ? The pressure hose is the smaller of the two hoses at the pump.
-
Good morning 😊
-
The pump is driven via a coupling off the end of the flywheel shaft. Does the coupling look complete ? Is there enough hydraulic oil in the tank ? Is the hydraulic oil clean or does it look contaminated ? I would check the fittings are tight on the pump in case it's sucking in air ?
-
What happens when you override the No-Stress by turning the tap by the No-stress solenoid valve through 90 degrees ? Do the feedrollers then operate in forwards and reverse on the red bar ?
-
Good morning 😊
-
Did you not get up yesterday ??
-
Good morning all and happy Friday 😊
-
Where are you Stubby??
-
Good morning Arbtalkers 😊
-
Good morning all 😊
-
Good morning all 😊
-
Good morning 😊
-
Haha 😂😂 Good morning Les and good morning all..
-
Good morning 😊
-
Gear driven maybe ?
-
It looks like a 'Bib' valve to me in which case the spool needs to be slid out and there is an 'o' ring either end in a machined groove in the housing.
-
Haaaaapppppyyyy Friday 🥳🥳
-
Good morning 😊
-
Good morning all 😊
-
I believe a lot of these axles are built to spec for the manufacturers hence they can't always be purchased direct ?
-
Good morning Stubby 😊 Good morning Arbtalkers...
-
Good morning 😊
-
Good morning 😊
-
Good morning Stubby 😊 Good morning to all ......
-
Happy Friday everyone 🥳🥳
