Sequoia Issue

[sean]

I need to replace the bridge on my Sequoia harness. Unfortunately the bolt that secures the ring has seized and is now rounded off leaving me unable to undo it. Does anybody know where and how to buy a replacement ring as I will have to cut the existing one off?

 

Any help much appreciated.

[Riggerbear]

I'm not sure replacement rings are available but I could be wrong.

You could replace them with a shackle type connector that other harnesses use.

[chris23a]

I remember reading somewhere on here that petzl don't sell the rings on their own and the only way to get it replaced was to send your harness off to petzl. You could try a different type of ring though?

[Steve Bullman]

I remember reading somewhere on here that petzl don't sell the rings on their own and the only way to get it replaced was to send your harness off to petzl. You could try a different type of ring though?

 

This used to be the case for the mark 1, I have a feeling they changed this with the mark 2 though so they may well be available by now. Im sure if you contact one of the arbtalk sponsors they will be able to tell you.

[Darrin Turnbull]

Here you go.

 

https://honeybros.com/Item/Petz_Ring_Open

 

The gap is 11 mm.

[sean]

Here you go.

[ATTACH]174585[/ATTACH]

 

https://honeybros.com/Item/Petz_Ring_Open

 

The gap is 11 mm.

 

Brilliant thanks for that. My local dealer had said that I would have to send my harness away. Good news