Jump to content

Log in or register to remove this advert

Recommended Posts

Log in or register to remove this advert

  • Replies 26
  • Created
  • Last Reply

Top Posters In This Topic

Posted

Thanks. The nail ruined it as the chain's sharpness was significantly reduced. I still went through it in about 7 minutes, stopping for wedges. I have never used a single-powerhead setup so hard to compare.

Posted
granberg ripping chain I find the best for milling

this is chestnut on granberg chain smooth cut

and BIG J said most of what I would have said

oh and rod D do these

Products for the category: Metal detection

 

I had seen your efforts in another thread, which convinced me to have a go at that chesnut. I have a ripping chain and a full skip one as well. As I just got the mill, I assumed the spare was sharp (i know, I know...) so when the skip went, no backup and poor cutting performance. I hope i'll get a better finish from my next cut.

Posted
it all takes time I hate setting up it gets easier and quicker

the more u do the better/ quicker u get

another good bit of kit and I wont leave home with out it when milling is

Products for the category: 12 volt grinders

 

Just ordered goodies off Rob's website. Extra chain, grinder, helper handle (in case I lack a camera-shy helper) and a few plastic wedges.

 

I had replied to Big J but the post disappeared after initially appearing quoting a post from another thread. Basically I fixed the ladder by clamping it with three strips of ply as I had to borrow it and the owner obviously did not want me to drill through his rungs! :001_tt2: It was nice and solid and didn't move so that was good, although I had to get new screws as the coach screws I had would have popped out over the heigh of the ladder.

 

Regarding the see-saw, I had to finish that top cut event though the chain really was way below the sharpness required. The only saving grace was the sheer power of the two 76's driving it. I would have preferred to take the saw out, resharpen and come back today to finish but as I said, the ladder was borrowed so needed to come back. The see-saw was the only way to get it to bite but obviously the finish is a bit poor as a result. Will plane ok I'm sure and I hope the next cut will be much smoother once I have three fully sharpened chains.

 

With regards to metal, if you check the whole log and get a result with a detector somewhere in the middle, what can be done? Do you just abandoned the job as how can you now exactly where it is? Obviously I've learned the hard way 5cms into my first cut what metal does to a chain and with 135 links that's a whole lot of cutters to resharpen! :blushing:

 

Thanks for all the feedback, will post pictures of the next boards, which hopefully will improved. I plan to stack them without batons and fully strapped to avoid too much warping.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  •  

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.