Ms326

[vernon28]

can any one tell me if my ms326 will take a 24" bar, my m8 dosnt think it will but it will take a bigger bar than that won't it ??

[Matthew Arnold]

can any one tell me if my ms326 will take a 24" bar, my m8 dosnt think it will but it will take a bigger bar than that won't it ??

 

You mean MS362? And your m8 is right it wont take anything bigger than 20 inch bar.

[vernon28]

Yes I did mean ms362! Oops! If the bar fits though shourly it would pull a chain around?

[Matthew Arnold]

Yes I did mean ms362! Oops! If the bar fits though shourly it would pull a chain around?

 

It would pull it round but wont do the clutch much good. And would bog down very easily.

[mendiplogs]

It would pull it round but wont do the clutch much good. And would bog down very easily.

 

HI MATE better off with a 660 the best for that size bar jon

[morten]

You mean MS362? And your m8 is right it wont take anything bigger than 20 inch bar.

 

I've been running an MS361 (earlier generation) with a 25" bar (3/8" full chisel chain). You have to nurse it a little, but it'll get the job done.

Wouldn't plan to use this combination exclusively, though.

[Dak]

18" on mine and she goes!!

[GardenKit]

but it'll get the job done.

 

 

I reckon its more to do with your ability to use the saw, than the saws ability to carry this bar.

 

In the wrong hands the saw would not last long methinks.