Hydraulic Rams

[windfall]

Hi All,

 

I am rebuilding a loader for my tractor, just about got it mounted but next hurdle is the knackered rams. Chrome is rusty in a good few places and the seals are shot.

 

Does anyone know of any places who can recon the rams for me?

 

Cheers

[niftysteve]

Hi All,

 

I am rebuilding a loader for my tractor, just about got it mounted but next hurdle is the knackered rams. Chrome is rusty in a good few places and the seals are shot.

 

Does anyone know of any places who can recon the rams for me?

 

Cheers

most decent hydraulic suppliers can either fix them or send them off to be fixed

might be worth calling these up for a price on new rams (sometimes cheaper than fixing )

 

 

Welcome To Flowfit Online

[Peter]

Ag engineer is often a good bet, rebuilding a ram isn't rocket science.

[Tyz05]

You will prob be better off having your local engineer fabricate new rods and welding the pin boss back on. Depending on size you might find someone to repair them. I'll check my phone book later.

[windfall]

I have found someone who can weld a new threaded connector on to a ram that was given to me, had previously discarded them from the project due to this hydraulic connector thread being so rusty it wouldnt seal.

 

So with that fixed hopefully ill have two rams that i can utilise once the holes are drilled out to 25mm.