dreaded chipper strikes again!

[farmer rod]

ive soaked them in wd40 tonight ready for tomorrow! its a seriously **** design all the newer engines have mounting plates on the side for easy access

 

so did they come out?? or are you still drilling

[Timbermcpherson]

Get heat onto em, and get a can of crc freeze. Those and easy outs shift most things.

[TREE-SURGEON-ESSEX]

Drill out the centre with a small drill bit untill your near the edge then tap it into the middle breaks up clean up the thread job done works for me

[White Noise]

I wish people would ad there location If close enough I would give you a lift

[simonm]

so ive finally got the bleeders out after a can of wd40 3 stud extractors 2 drill bits and lots and lots of swearing!!! time to sort that frickin roller out now!