No oil coming from my bar/ chain

[skc101fc]

On 14/08/2025 at 02:46, Hog a Log Hogson said:

I dont know where the oil inlet hole is

 

[skc101fc]

4 minutes ago, skc101fc said:

 

Oooh didn't mean to do that... was just about to say one of the easiest places to clog up, and also easiest places to clear is the little hole where oil enters the saw bar, and then onto the moving parts of the chain. A small hole of about 2-3mm diameter on the upper part ofhe bar, about 5mm down from the top guide rail surface, where the bar is clamped to the engine. 

Shouldn't have to be describing this , but I'm beginning to feel that maintenance and regular care don't occur very often with this case.

[Mark_Skyland]

If you're  local to me please don't being it in for repair. I've had a few machines in that have had used engine oil for chain oil. They either get picked up without me looking at them or get binned. The next down the line is veg oil machines!