Jensen Feed Rollers

[WesD]

On 01/11/2017 at 19:46, Woodee said:

Thanks All for the advice Think I'll get a dremmel and replace the spring

Mine's a 2009 model with a single spring with a couple of adjuster nuts top and bottom I had to remove the whole unit and put some heat on it to free up the nuts!!!

Also WesD I take it the £180 was for parts only ?

Yes parts only mate, not hard to change over though.

[WesD]

[WesD]

The throttle cable sort of works back to front in that when you push the lever forwards the cable tightens therefore compressing the spring taking the revs off. When you pull the lever the cable slackens therefore the spring extends pushing the rod with is connected to the pump giving you more revs. As far as I can see there is not much room for adjustment other than replacing the spring or shortening the cable. 

[swinny]

How wierd is that then! 

 

Colletti has 2 springs on the top roller on the outside. 

 

Wes d you have 2 springs on the inside near roller motors etc!!! 

[WesD]

Yes that is strange! In my workshop manual they seem to be in the right place for mine. There seems to be a few variations for these Jensens!

[Woodee]

On 03/11/2017 at 19:01, WesD said:

Yes parts only mate, not hard to change over though.

Cheers WesD parts ordered so I know my job for the weekend !!

[WesD]

54 minutes ago, Woodee said:

Cheers WesD parts ordered so I know my job for the weekend !!

No probs, its easy mate and makes a great difference!