362xp spluttering ????

[Nukeproof]

Iv had my husq 362 xp for about 10 years and I was my everyday destroyer for about 7 of those but after sending it into dicks for a check over they said it was going to be expensive . So I put it in the shed and there it has sat till now !!! Iv had it out and it is really splutter and then it just won't get a spark . I was thinking about just trying a new coil has anyone had any experience of this ???? As I forgot how good it felt to cut with it compared to the new alternatives !!! Any advice is more than welcome

[Eddy_t]

The normal husky coil for the 3 series saws will fit the saw, but you may find you need to replace a few bits if the saw has been sat for 3 years

 

 

Sent using Arbtalk Mobile App

[Ray1]

Try a new plug before you shell out for a coil.

[Mull]

try a new plug before you shell out for a coil.

 

 

..👍..

[Nukeproof]

I should have said it had a new plug it it when I stopped using it . I tried everything else I could think of bar the coil but as it been sat I might throw a new fuel filter in . Cheers for the replays guys

[spudulike]

Try closing the gap up between the coil and the flywheel, just make sure it doesn't touch the flywheel.

 

Also try disconnecting the blue wire off the coil and see if the spark comes back.