Tw150 stress

[hamdogg]

Problem with my 150, when I'm chipping larger material and the stress kicks in, the rollers stop as they should, but then won't start going again, I have to reverse the rollers and keep pressing the green forward button and will eventually kick in and and start again!

 

Suggestions

[htb]

Have you tried changing the latch relay beside the stress control box, its a normal relay available from car shops

[hamdogg]

have you tried changing the latch relay beside the stress control box, its a normal relay available from car shops

 

 

[hamdogg]

Have you tried changing the latch relay beside the stress control box, its a normal relay available from car shops

 

 

Not sure! I'm no good with stuff like that lol

[htb]

Thats the one, partially covered by the white mounting pin in the bottom right of the pic.

there only a couple of quid, just pull it out of the connecter and replace, worth carrying a couple

[hamdogg]

Thats the one, partially covered by the white mounting pin in the bottom right of the pic.

there only a couple of quid, just pull it out of the connecter and replace, worth carrying a couple

 

 

Cheers I'll try it 👍🏻

[Riggerbear]

Start with taking the relay out and giving the pins and maybe the terminals a clean, still no joy then try a new one

[hamdogg]

Start with taking the relay out and giving the pins and maybe the terminals a clean, still no joy then try a new one

 

 

Cheers! I'll try it tomorrow see if any luck 👍🏻

[Gerbutt]

Make sure the throttle isn't vibrating back a little bit, it happened on mine with the same sort of symptoms.