Jump to content

Log in or register to remove this advert

Air Spading near underground services


David Humphries
 Share

Recommended Posts

Slightly unusual job this week.

 

We have a number of reservoirs at work which are having their Dam structures reinforced.

 

One of these dams has a number of underground services running along it including gas (yellow), mains electricity and street light cables (both red).

 

The blue line is where the gas pipe is being re-routed due to the reinforcing works.

 

The new route of the gas pipe runs through the root protection area of two large London Planes (Dbh > 104 cms)

 

 

 

.

59766e5d7afa1_Damgasimage-Copy.jpg.c3d7c8da284689d848d4f925d7f2c519.jpg

Link to comment
Share on other sites

Log in or register to remove this advert

.......The new route of the gas pipe runs through the root protection area of two large London Planes (Dbh > 104 cms)

 

The contractors were planning to use a digger to trench out the new route which would undoubtedly have severed substantial roots from both trees.

 

We decided to utilise an airspade to excavate the trench instead.

 

Firstly we had the area scanned with a Cat & Genny to confirm where the existing services were. (can't always trust service maps :001_rolleyes:)

 

 

.

IMG_4394.jpg.d2d9006e4f95f5e967e087a447c2d2a9.jpg

Link to comment
Share on other sites

Although we've used the airspade to uncover roots before we hadn't worked near to known underground services.

 

On top of our own generic & site specific R/A's and SSoW the only guidance we could find on carrying out work on or near underground services was the HSE document HSG47 (2014) 'Avoiding danger from underground services'

 

Avoiding danger from underground services - HSG47

 

 

 

Does any one else know of any further docs available on the subject?

 

 

.

44.jpg.3069f43b71e6238c93393819f5f06974.jpg

Link to comment
Share on other sites

Although we've used the airspade to uncover roots before we hadn't worked near to known underground services.

 

On top of our own generic & site specific R/A's and SSoW the only guidance we could find on carrying out work on or near underground services was the HSE document HSG47 (2014) 'Avoiding danger from underground services'

 

Avoiding danger from underground services - HSG47

 

 

 

Does any one else know of any further docs available on the subject?

 

 

.

 

Hi David, someone's already mentioned NJUG v.4 (attached) but this is more focused on protection of tree roots.

 

Have you tried that very well known search engine and perhaps some keys words, e.g. "method statement for excavations for underground services"

...hint, hint.

 

Cheers..

Paul

 

PS Think BS5837 has a section as awell but again focused on tree protection measures.

V4-Trees-Issue-2-16-11-2007.pdf

Link to comment
Share on other sites

Just out of interest ,wouldn't the compressed air jet damage roots by injecting air into them and by physical damage to the root surfaces? I know it will be less than a digging bucket crashing through them .

 

from our experience we've found that fine roots (and associated mycorrhiza) can be torn away from the parent root by the force of the compressed air and it can also dislodge stones (& other debris) which can cause impact damage to other roots. But generally, the air doesn't rupture through the root bark on mature roots.

 

With care, this level of damage can be limited, and the fine root hairs can regenerate over a short period of time. Particularly in loosely compacted soils.

 

This below vid shows the airspade/root interface at relatively close range (from about 2.40 secs)

 

[ame]

[/ame]

 

.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.