Smallest diameter worth milling ?

[Rob D]

Yes, but I'm still looking forward to some good advice on which mill others recommend to produce specific sawn timber that there is :thumbup1:always demand for.

 

 

That is a hard one to answer but the best quesiton you should be asking!

 

 

In some ways an Alaskan is a good way to start - mill some boards and see if you can sell them. Then if there is demand there you can get a bandsaw.

 

 

Some people buy an Alaskan saying that carpenters around them are begging for timber - others have a stack of boards in the garage they are struggling to sell... so it depends on where you are and who you know!

[arboriculturist]

That is a hard one to answer but the best quesiton you should be asking!

 

 

In some ways an Alaskan is a good way to start - mill some boards and see if you can sell them. Then if there is demand there you can get a bandsaw.

 

 

Some people buy an Alaskan saying that carpenters around them are begging for timber - others have a stack of boards in the garage they are struggling to sell... so it depends on where you are and who you know!

 

That's sound advice.

 

I have seen many posts on the Forum where others have struggled to market their products.

 

I anticipated slabbing 2" /2 1/2" & 3" which is what the majority of joiners use, along with 6" x 12" lintels.

 

Anyone else any ideas of what sells?

 

It can sit there stickered up for as long as required to sell. I have been told by many, there is a strong demand for air dried British hardwoods.

 

I am thinking its all about building a reputation for quality products at a good price.

 

It's going to have to be the Bandsaw route though - Woodmizer LT70 I expect unless I encounter anything better for a similar price.

 

Any replies welcome.

[Big J]

Agreed, the setup time has to be considered. I did PM you about Bandsaws etc a few days ago - expect u r very busy like us.

 

Just checked my inbox but nothing through from you?

[arboriculturist]

Just checked my inbox but nothing through from you?

 

That will be me John - i'll sort now:001_rolleyes:

[arboriculturist]

That is a hard one to answer but the best quesiton you should be asking!

 

 

In some ways an Alaskan is a good way to start - mill some boards and see if you can sell them. Then if there is demand there you can get a bandsaw.

 

 

Some people buy an Alaskan saying that carpenters around them are begging for timber - others have a stack of boards in the garage they are struggling to sell... so it depends on where you are and who you know!

 

Is there a strong market for used Alaskans, if we buy one then upgrade to a bandsaw?