Jump to content

Log in or register to remove this advert

makita piston ring end gap


Breezeblock
 Share

Recommended Posts

Log in or register to remove this advert

could any body tell me what end gap should be on the piston ring when its shoved into the bore we stripped it expecting to see a picked up bore and piston but can't see anything wrong now thinking worn piston rings as the air filter seals rather poor on it

 

anything between 5 - 20 thou, with the former being on good new rings.

 

You can normally tell when the ring gets worn as the ends becone a lot thinner than the rest of the ring.

 

Check the bore is ok with the plating not worn through.

 

Measure the compression - on smaller engines it can feel low but still measure up OK.

Link to comment
Share on other sites

Out of interest,where in the bore are you positioning the ring to measuring the gap, try worn and unworn section of the bore and see what if any difference there is .also are you pushing the ring down with the piston to make sure its sitting square in the bore?

Sorry if I teaching to suck eggs and all that!!

slim

Link to comment
Share on other sites

Out of interest,where in the bore are you positioning the ring to measuring the gap, try worn and unworn section of the bore and see what if any difference there is .also are you pushing the ring down with the piston to make sure its sitting square in the bore?

Sorry if I teaching to suck eggs and all that!!

slim

 

there is no difference where the ring sits in the bore and yes i am using the piston to make sure its square the end of the rings look perfect as in identical i am now thinking sloppy manufacture and plenty of tolerance not wear as i first thought

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

Articles

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.