ms 210/250 assembly

[MATTMOSS]

What is the best way of putting the engine back in the housing.

Do you seal the crank pan on the cylinder first with the seals in place and try to fit as a complete unit or just build it in to the housing bit by bit?

looks like it will be a struggle to get the seals in afterwards as the oil pump is in the way- or should I remove this?

any advice?

thanks

[landrover 101]

Have a look through the stihl manual

 

Will pm you where to find it in pdf

 

 

Sent using Arbtalk Mobile App

[Ray1]

piston attached to crank (with seals in place), slide the piston into cylinder, dirko the base pan and fit it onto cylinder then slide the lot into place and bolt down.

[wisecobandit]

Yeah what Ray said.

The suction of the sealer and seals hold the sump pan on fine. Fit it then install the 4 rag bolts to pull it all up. Don't over do it the sealant.