Schliesing 300 mx

[Wainy]

Had something similar with our schliesing ended up being wrong angle on the cutting edge of the blades, rollers were trying to push wood into body of the blade not cutting edge. Just a thought as you mentioned you'd changed the blades

[ray north]

Ok I will give that a good look over thanks for the help.

[ray north]

Thanks the blades were sharpened professionally so should be fine.

[ray north]

Thanks I did the springs up quite tight might try loosen them,

 

I don't have any pics I will try to post some soon.

 

Getting very frustrated with her now it is such a good machine usually. Don't wont to put in a shop for them to come back with something small which I could have done.

[timtree81]

Thanks I did the springs up quite tight might try loosen them,

 

I don't have any pics I will try to post some soon.

 

Getting very frustrated with her now it is such a good machine usually. Don't wont to put in a shop for them to come back with something small which I could have done.

 

I have run and used lots and you will be hard pressed to find a better chipper than yours

[Wainy]

Our blades were done 'professionally' too but not at the same angle as the new ones that finally made an improvement!

[bunnybasher100]

30 degrees on the blades, have to saw scheisling are built well witnessed a felling lever going tru a 200mx and the only things that needed replacing where anvils, rope cutter and blades.

[mrstumpy]

I can empathise your and with your problem, I have a similar machine, obviously you have checked the tensions in the springs on both sides of the feed rollers.

 

Mine suffers from debris collecting under the feed roller arm (trapped between the arm and the chipper frame) so the rollers do not close together properly. In your instance perhaps it is worth having a look at the rubber stops (i.e. have they moved) or the ingress of some type of foreign material preventing adequate pressure between the feed rollers.

 

Just a suggestion