Petzl Sequoia bridge

[WorcsWuss]

Replaceable bridge for above, anyone tell me whether a standard krab will fit through the sewn eyes....?

Thanks!

[RobArb]

may be a bit of a squeeze but the smaller dmm's might.

 

why not just put it on properly though, don't fancy the ring to krab combo meself?

[AlvinD]

Use abit of silver streak Prussic rope with double fishermans at either end?

[WorcsWuss]

Snot for that, was thinking of using one as the basis for an rw tether..... Cheap, neat and 3 options all around the right length.... Stiffen it up and presto....

 

Course I could be wrong, but for around a tenner it's not an expensive experiment.....!

 

Thanks for info though!

[RobArb]

Do try the smaller dmm ones, think you might be surprised.

 

The bridge also comes in 3 sizes which is handy:biggrin:

 

Where you going to shrink wrap it?

[Dan Curtis]

Just had a look at a couple I've got. One has big eyes, the other has small:confused: both from the same supplier

 

Probably pot luck as to which you get but yeah you should get a crab through either, dmm shadow gets through the little one with ease.

 

How were you planning on stiffening it?

[WorcsWuss]

Do try the smaller dmm ones, think you might be surprised.

 

The bridge also comes in 3 sizes which is handy:biggrin:

 

Where you going to shrink wrap it?

 

Thought I'd probably do it in my shed..... :lol:

 

I have looked into the quickdraws, if I stumble on one I'll get it, but they don't seem to be stocked by the usual suspects.....

 

I do have a very short hitch, going to start with a 25cm bridge and go shorter from there.....

[WorcsWuss]

Just had a look at a couple I've got. One has big eyes, the other has small:confused: both from the same supplier

 

Probably pot luck as to which you get but yeah you should get a crab through either, dmm shadow gets through the little one with ease.

 

How were you planning on stiffening it?

 

Not sure yet, whatever I have lying around, will experiment but so far am settled on covering it with an off cut of aeris cover inside clear shrink, binding black silage wrap repair tape around something under that, not sure what yet....