Old Red

[ContractArb]

A mate of mine has an old Jonsered 111s

 

Unfortunately we think it needs a new piston

 

Does anyone know if parts are available for these? Methinks not but there's a rumour that parts from an old Husky would fit....

 

Help please..

[Cut4fun]

I know where brand new NOS OEM 111 top end kits are on this side of the pond. Couple of them.

[cousin jack]

Try this forum, someone will know for certain sure.

 

Chainsaw Collectors

[Cut4fun]

PM Magnus on CSC post above. He runs that site.

 

I do know a sachs dolmar 166 piston has been run in a 111 hotsaw. I dont know of a husky one.

 

Just some eye candy to make you want to get the old girl going again.

 

[ame]

[/ame] Edited December 12, 2011 by Cut4fun

[spudulike]

If you pull the piston out, post the gudgeon/wrist pin diameter, piston diameter, piston height and top of the wrist/gudgeon pin to piston top edge dim as well as noting if the piston is domed or not.

 

Once I have this info, I can do a few checks!

[Cut4fun]

If you pull the piston out, post the gudgeon/wrist pin diameter, piston diameter, piston height and top of the wrist/gudgeon pin to piston top edge dim as well as noting if the piston is domed or not.

 

Once I have this info, I can do a few checks!

 

I'm working through emails trying to get you the oem 111 piston specs from one of the new kits.

 

If OP would post some pics of his P + C might be able to tell if can be cleaned up and re-ring it

 

I'm betting it nust have a big pin. The 166 had a big pin. I know a guy that drilled a 394 piston to work in a 166.

 

Let you know spudulike when and if specs get emailed back to me.

[Cut4fun]

Spud here is a new oem 111 piston spec. That way you can help dude over there.

 

diameter 56mm

wrist pin diameter 14mm

piston skirt width 39.79mm

piston height bottom of skirt to top of piston 49.86mm

[Cut4fun]

here is a 166 wiseco piston that works in a my 166 racesaw and stock saw 166. Also OEM 166 in 111 racesaw and a 394 piston can be made to fit 14mm wrist pin and work.

 

[Cut4fun]

New oem kit.

[spudulike]

Sorry - closest fit is a Husqvarna 394/395 and 2100CD but both have 13mm wrist/gudgeon pin sizes and have open sides - drawn a blank on this one!