What's on your bench today?

[spudulike]

The latest MS200T, looks like it has seen some life but compression is good, going to give it a full refurb and port/tune. A number of parts on order and now looking a fair bit cleaner: -

[Rich2484]

You have a ghost in the picture spud....

[spudulike]

Yep. Going to do the transfers at some point. Gave up testing after it got too hot......... Oops.

 

To be honest I didn't notice much difference after I had done the exhaust port and baffles. I doesn't sound like it runs any faster or harder. But then without the drum doing its work properly I guess I won't.

 

Strange - you normally notice a far quicker pickup and heavier fourstroking where the saw would normally top out allowing higher maximum revs.

[Rich2484]

Oh it revs ok.... So much so that the ruined drum tells me so.

 

Just not much in power on the cut. I need to sort a new drum sharp ish. Do you know the IPL for the dollars. And what drum will fit the 116. I'm really having trouble with it.

[spudulike]

Oh it revs ok.... So much so that the ruined drum tells me so.

 

Just not much in power on the cut. I need to sort a new drum sharp ish. Do you know the IPL for the dollars. And what drum will fit the 116. I'm really having trouble with it.

 

Try This - http://www.bethnchris.com/files/chainsaws/sachsdolmar/116si_IPL.pdf

 

Oregon part - rim sprocket 27189X will fit as will Spur sprocket - 38075X

[Rich2484]

Cheers spud. Will have a look for one.

 

 

Ebay only seems to come up with America. Could be a long wait. Not looked into the shops yet.

Edited April 22, 2013 by Rich2484

[spudulike]

Cheers spud. Will have a look for one.

 

 

Ebay only seems to come up with America. Could be a long wait. Not looked into the shops yet.

 

See if Gustharts can get one in for you - pretty good service in the past:thumbup:

[Eddy_t]

What about rob d? He might be able to source you a sprocket

 

 

Sent using Arbtalk Mobile App

[Ricbob]

Im popping a new piston in a ms200t, anybody got a neat way of installing the spring clips?

Iv'e got the type that dont have the little handles that you can grip with pliers. i know there's a tool but not going to buy it just for one piston.

Thanks

[Rich2484]

A very small electrical type screwdriver and a finger covering the clip while doing it or you will never find it again....

 

Good luck.