this years log tipper

[gensetsteve]

Old truck new body

[log supplier]

nice.. like the swinging tail gate:thumbup:

[tree_beard]

ooooh shiny...

 

whats the truck payload with the new butt? and how much did it set you back?

[gensetsteve]

nice.. like the swinging tail gate:thumbup:

 

Thanks

had it on the road about 2 months a joy to use should have done it sooner. The raised hinge means logs dont jam. 2 Cube out in one hit.

[gensetsteve]

Payload a bit of a grey area but 750 kg. Body is too well built. With a few mods and a later truck I think you could get to 900kg. With vat and all the extras it cost just short of £3000

[tree_beard]

Body is too well built.

it does look very sturdy, and probably the most professional looking pickup-tipper conversion i've seen. very smart

[gensetsteve]

Built by Boulters Tippers of Tadley. Highly recommended, new ram, new pump, new lights and brackets, slide out divider, steel floor with tye downs. Anodised aluminium sides. Not over built but right for the job.

[log supplier]

should put a strong wire cage around the rear lens, to protect the lights when tipping:thumbup1:

[Busy Daddy]

My pickup is very similar , i have put a single release pin at the bottom so you dont have to get out of the pickup to tip

Sounds very lazy , but very handy for tipping in narrow garages or alleys , and if its raining dont want to get wet do we .

[farmer_ben]

HOw much do you sell that load for if you dont mind me asking??