Tp 760 woodchipper

[Seanp]

8 hours ago, GarethM said:

That's the anvil page.

 

TP_150.pdf 41.47 kB · 4 downloads

Thanks a million 

[openspaceman]

On 14/02/2024 at 08:21, Seanp said:

That would be great thanks. 

tp760.pdf - Google Drive

DRIVE.GOOGLE.COM

I'll leave it up on drive for a week or so

[Seanp]

20 minutes ago, openspaceman said:

tp760.pdf - Google Drive

DRIVE.GOOGLE.COM

I'll leave it up on drive for a week or so

Thanks a million 

[aspenarb]

As said a fag paper clearance, worth taking into consideration a tad of float on the rotor shaft bearings or bearing housings. There can be a small amount of wear in the bearings and or the bearing housing which will let the rotor walk, I always load the shaft towards the anvil when doing the clearances. 

 

Bob

[HNK]

On 16/02/2024 at 22:27, openspaceman said:

tp760.pdf - Google Drive

DRIVE.GOOGLE.COM

I'll leave it up on drive for a week or so

Hello,

Can you re-upload it? have been looking for the TP760 pdf online but could not find it

[openspaceman]

2 hours ago, HNK said:

Hello,

Can you re-upload it? have been looking for the TP760 pdf online but could not find it

If you PM an email address I can send it, very little space left to upload.

Edited December 29, 2024 by openspaceman