30% Full Crabide router cutters

[gobbypunk]

So have any of you guys used these cutters we had a Thistle and a Celtic Cross to ingrave into a back of a bench and there just wasn’t the room to use a standard V cutter so after a load of looking we got one of these it was only a fiver and wow it was just cutting through the Cedar so easy there was just no resistance at all and that kinda made it difficult but yeah you could almost draw free hand with it I will post some pictures tomorrow 

Cheers. Mark

[spudulike]

Get a pic of the cutters up Mark, they may be the ones I use for porting and loads of other stuff, purchased a few sets but they last an incredible amount of time and cost bugger all. 4mm dremel shaft I think

[Sviatoslav Tulin]

I am fussy today,might I ask what 30% FULL carbide mean🤷🏿‍♂️

[gobbypunk]

So 30 degree angle on the cutter and made out of Carbide not Carbide tiped