go 2 mill

[jose]

Has anybody used this? Saw it at the arb show and my friend was quite keen. Ived never heard of it before and wondered if anybody has used it and can offer feed back.

Its basically a sliding clamp which you attach to a metal beam ( 4 inch square which u screw to the log) and a large thread you attach to the saw via one of the bolts where the side casting is.

My only thought is there is a lot of weight / pressure on that one bolt so is this going to end up snapping in a short amount of time?

website is a bit vaugue to say the least. go2mill.com

Many thanks

 

[Woodworks]

Got to see this at the show yesterday. First glance it looked a good idea but as you point out that single bolt attachment is a major flaw. Also looking at a video of it in action there was chap spending his whole time spraying the guide bar with lube. Think I would pass.