Palax Paint touch up

[Lillywhite Timber]

Hi , i have a KS 350 ergo processor . Purchased it secondhand , little use . So far so good , im very impressed despite a lot of guys telling me circular saw types were the only way to go .

Trouble is there are a couple of areas with rust on them . The red on the end of the conveyor and the grey at the very bottom on the stands .

Im wondering where id get paint to touch it up , its localised enough luckily but annoying !.

Id say an aerosol and hard sanding and priming would do it but i will get it touched up by a pro if i have to .

Is there any specific RAL or shade ? , it almost looks like a Massey Ferguson paint scheme .

[Goaty]

Id email palax. No manufacturer has yet failed to sort me out. Ive done it about 4 times a d one was italian.

 

Sent from my LG-K100 using Arbtalk mobile app

[Arborist]

Thing is if the steel wasn't blasted properly or it was blasted and left hanging around for a bit before painting you will probably get bits of rust breaking through from under the paint.

[Lillywhite Timber]

Thing is if the steel wasn't blasted properly or it was blasted and left hanging around for a bit before painting you will probably get bits of rust breaking through from under the paint.

 

Fair point , it looks as if this may be the case