Entec 150 blades

[hamdogg]

Hi there can anyone help me I need to get some new blades and bolts for an old entec 150 diesel chipper? Where can I get them from?

 

 

Sent from my iPhone using Arbtalk

[roseyweb]

Same as TW150

Saturn machine knives

Spectrum Plant

[hamdogg]

Ok thank you and how do I reset the anvil once I've put new/sharpened blades back in?

 

 

Sent from my iPhone using Arbtalk

[MrPaul]

The anvils are stationary, both are held in by two bolts. If they are worn either turn or replace them.

 

The anvil gap is set when the rotor is fitted (or re-fitted) to the machine.

[hamdogg]

So I don't have to worry about re setting anything when I replace the blades?

 

 

Sent from my iPhone using Arbtalk

[Johny Walker]

So I don't have to worry about re setting anything when I replace the blades?

 

 

Sent from my iPhone using Arbtalk

 

no theyer pre set ,just refit the new blades,baring in mind they only have a 10hr chipping life

[Johny Walker]

So I don't have to worry about re setting anything when I replace the blades?

 

 

Sent from my iPhone using Arbtalk

 

make sure you clean all the crap out of the torx head ,or youl nacker them then is a drill out job,

remove the springs on the roller box then lift it up & wedge a lump of wood under it it makes for better access to the blade pocketys

[hamdogg]

It's allready a drill out job the torx heads are knackered! So drill em out and put new blades and bolts in

 

 

Sent from my iPhone using Arbtalk

[Johny Walker]

It's allready a drill out job the torx heads are knackered! So drill em out and put new blades and bolts in

 

 

Sent from my iPhone using Arbtalk

 

if you can cut a groove in the torx head you may be able to nock them loose wi a smaal chisil,

[hamdogg]

Yeah I'm gonna tackle it tonight, I'll see how I go on with them!

 

 

Sent from my iPhone using Arbtalk