Oregon sprocket options for Husky 435

[Rob D]

A member on here is after a different sprocket for this saw ie. 3/8 lo pro or 1/4"... to run a carving bar....

 

 

Anyone know if this saw takes the same sprocket as any other older model saws?

 

 

 

 

[Roni Macdonald]

I too have been looking for a carving set up for the 435 but no luck. If you come across any, please let me know.

[wisecobandit]

The same as a 440e if that helps? 435, 440, 445, 450, 455, 460 range.

crank shaft diameter is 0.472

Not sure if the code csr14 helps but that's the 1/4 drive sprocket a big American supplier uses ;-)

[Rob D]

The same as a 440e if that helps? 435, 440, 445, 450, 455, 460 range.

crank shaft diameter is 0.472

Not sure if the code csr14 helps but that's the 1/4 drive sprocket a big American supplier uses ;-)

 

 

 

Ha ha - good work - baileys have them I see...

 

 

Oregon rim sprocket - very handy so then 3/8" lo pro and 1/4" are options...

 

 

....put that into oregon webshop - invalid material number!

 

 

Not available in the UK - I will get onto it!

 

 

[wisecobandit]

Woodland international Mpn: RSM-250-9 may also be a helpful code?

[Rob D]

Woodland international Mpn: RSM-250-9 may also be a helpful code?

 

 

 

Thanks - I have an account with them - this will be a re badged oregon sprocket so if I don't have any joy with Oregon UK then I will see if I can get a load over..

 

 

 

[Rob D]

Been a bit thick here...

 

 

Part number is 36868X

 

 

So oregon do have them in stock as as well... I have ordered a load and then change the rims over to 1/4" or 3/8" lo pro.

 

 

Will put some pics up here and also list them on the website here in the carving sprocket area Carving sprockets

 

 

[Rob D]

Hmmm - got a load of these but they have the 3/8" standard rims on them... (rims come in small and standard spline sizes)... so the smaller 1/4" rims do not fit on them...

 

 

 

.