Husky T435: Over revs, and continues after trigger release.

[Smith126]

Afternoon,

 

My colleague is having problems, his Husky T435. The saw runs high revs, but when he releases the trigger, the saw continues to rev high for anything from 30 sec - to a good minute or two. Once it comes to idle, it stalls.

 

He's cleaned out the carb, checked the trigger and had the saw tuned by himself and the boss, but the saw still sounds like a formula 1 car. He's looking to take it into the shop, but thought I'd on here.

 

Have any of you had any similar problems...

 

Cheers

[Smith126]

Found the problem. Crack in a intake pipe between the carb and piston.

[Stubby]

Afternoon,

 

My colleague is having problems, his Husky T435. The saw runs high revs, but when he releases the trigger, the saw continues to rev high for anything from 30 sec - to a good minute or two. Once it comes to idle, it stalls.

 

He's cleaned out the carb, checked the trigger and had the saw tuned by himself and the boss, but the saw still sounds like a formula 1 car. He's looking to take it into the shop, but thought I'd on here.

 

Have any of you had any similar problems...

 

Cheers

 

Air leek some where . Oh sorry see you found it !

Edited September 23, 2013 by Stubby
Found the problem