Husky 372xp/xt

[thetoolnut]

I purchased a h.d air filter, (part number 503 81 80) filter holder (part number 503 81 78) and filter mounting bolt for my 2012 Husky 372xp/xt. The holes on the filter holder don't align with mounting holes on the Walbro carb. Anyone out there know of the correct part number for the filter holder?

 

Thanks.

[thetoolnut]

The h.d filter holder is on the left, the holes are aligned differently. Sorry about the picture quality.

[thetoolnut]

Hopefully this came out better.

[outinthewood]

My" 375"XP has the short version on its Walbro carb, but I'll check when I've had tea and gone back in if it is the XT case as I'm not sure. The guy that built it for me used some XT stuff handle etc 

[thetoolnut]

My" 375"XP has the short version on its Walbro carb, but I'll check when I've had tea and gone back in if it is the XT case as I'm not sure. The guy that built it for me used some XT stuff handle etc 

Thanks, the bolt that holds the filter to the filter holder isn't long enough either.

[outinthewood]

Ok it is a 2013 bottom end and has the short version which is bolted up to a older 75cc top end. The 576 has two lenths of securing bolt not sure about 372s , have a look at the IPLs again ?

[thetoolnut]

The same for the 372xp/xt, the stock low pro air filter has two holes, one low and one high. The H.D filter holder i got doesn't match, the schematic shows a 2003 372xp, mines a 2012xp/xt.

[thetoolnut]

Finally sorted my H.D filter conversion, i got the X/T filter holder (part number, 522 02 45) and the air filter mounting bolt and knob (part number, 537 21 32-04). Now to retune with my tach.