Greenmech ec150

[Glenn123]

Hi all does any one no how much a stress control is for my ec150 chipper please and is it an easy fix I don't no much about them and new to industry thanks 

[Mick Dempsey]

@Pete B is your man for this. He’ll be along in a while.

[Jase hutch]

Pete's probably still in bed....

Glenn , which engine do you have fitted ..?

What happens to your 'no-stress' light..?

It should flash red with the ignition turned on and the override button pressed.

It should then be a solid red/orange when the engine is running.

Finally it should turn green when the engine is running at maximum revs..

Jase..

[Glenn123]

Hi please bare with be i will come to you I no it's a lister engine on the chipper all works chips but when the engine struggles you have to ease on the bar if makes sence thanks for getting back I will see tomorrow as not really looked at the lights hadn't thought to 

[Jase hutch]

Do the feed rollers pull in on tick over  ?

If so then have a look under the infeed chute by the no-stress solenoid valve, there is an override tap there with a lever , the lever should be in line with the hose fittings , if it's turned 90 degrees then the rollers will infeed on tick over.....

You might find that if the lever has been turned to the incorrect position , when you put it to the correct position they won't feed in as there is a fault the previous owner was trying to cover up..

If this is the case , try the above to see what happens to the no-stress light..

If you get a green light , you should then have magnetism at the no-stress solenoid valve (under the infeed chute) , checked on the nut that holds the coil in place..

Jase..