Cone splitter pulley bore advice???

[otter]

Would a Pulley bore size of 24mm be right for a 20mm shaft? This would be the small (100mm) pulley to go on the drive shaft on a petrol engine to drive the belts to large pulley on the cone shaft??

Cheers

[Stubby]

Would a Pulley bore size of 24mm be right for a 20mm shaft? This would be the small (100mm) pulley to go on the drive shaft on a petrol engine to drive the belts to large pulley on the cone shaft??

Cheers

 

Unless Im misunderstanding , you want to put a 20mm shaft into a 24mm hole ? Its just a guess but I would say that would wobble a bit ! A wind up surely ?

[otter]

I know it's sounds stupid, but there wouldn't be a 4mm cap, it would be spread around the internal diameter? So at a guess 0.75mm? All the way round.. This is why I'm asking

[otter]

It's alright, found an adapter sleeve to fit anyway, it's a should be snug fit now.

[Stubby]

It's alright, found an adapter sleeve to fit anyway, it's a should be snug fit now.

 

Phew !