Search the Community
Showing results for tags 'bearing'.
Found 3 results
-
we are replacing the bearings on the 190 and we have taken everything out and was just wanting to know if you have to take the 60mm nut off or if you can push the whole shaft out in one. probs a silly question would just like to know if it can be done
-
Hello all so I recent got a STIHL hs45 gifted you me it’s hard to pull over and rattles/ blades don’t move upon inspection it needs a new clutch as it’s loose and the clutch drum bearing had popped so new bearing fitted and re assembled to test (new clutch isn’t on yet) I cleaned and re lubricated the gear bid as necessary, hedge cutter fired right up and reeves the blades move success; however I can hear the bearing whearling like if you spin a sake board wheel is this due to the loose clutch or to you think it’s a bad bearing ps the blades move fine
-
This looks like the first post on this bit of the forum I've got an irritating little problem on my LT40, looking for any ideas to track down the problem. With the blade driving, there's a vibration/thrumming/ pulsing feel from the saw head. Sometimes the needle on the blade tension gauge jitters a bit as well. I've just changed blade belts (B57s) and made sure there's no bark jammed in the blade wheels, the blade guide bearings also seem to be good. Any ideas before I dig further? W
