Jase hutch

Good morning 😊

Sorry , just to update this , I believe I was given the wrong part number for the hydraulic pump and it is in fact: PEC150005/1 Jase.....

Hi Jack , We have the pump and coupling in stock. Pump : PEC150024 Coupling : EC150045 Best in speak to Pete in Parts regarding prices , on 01789 400044 option for Parts.

Good morning Arbtalkers 😊

I can find out price and availability tomorrow and for the drive coupling assembly...

The hydraulic pump for the feedrollers that's driven off the back of the flywheel shaft ?

Tracked machine ?

Good morning Arbtalkers 😊 Have a great day 👍

Et 150 ? EC150 maybe ? Has it got a Lister engine fitted ?

Nice one Chris 👍 Thanks for letting us know.

Good morning Stubby 😊 Good morning Arbtalkers and have a great day 👍

Roll over Beethoven...

Good morning Arbtalkers 😊 Happy Friday everyone 🥳

How did you get on ? @nuphor

What's echo plugging ??

Good morning Arbtalkers 😊 Another wet day ahead 🙄

Good morning Arbtalkers and happy hump day 😉

Good morning Arbtalkers 😊 Looking like a better day weather wise..

Good morning Arbtalkers 😊 Looks like being a washout this week 🙄

Yes I thought it was bigger and better than the last one and plenty of machinery 😊

Oh and another thing , try to find the black plastic 6 pin Bulgin plug , an example is shown in the attached image , should be located in the loom in the area of the battery. Separate the two halves of the plug and check it's clean and dry ? Jase.

Hello , Sounds like a stop switch issue to me ? If you locate the white square junction box up by the battery , remove the four screws and lift off the lid and look inside the box at the circuit board along the edge where the largest bunch of cables run. Locate the purple wire and the red/green where they are soldered into the board , there should be continuity between these two wires unless the stop switches are operated by pushing in the red stop bar. If there's no continuity it would suggest either one of the stop switches has failed or there's damage to the loom. Alternately you can remove the button boxes on the infeed flap , remove the small cover on each stop switch and check for continuity between the two wires , again there should be continuity unless the switch plunger is depressed . The same applies if your machine has red palm switches fitted on top of the infeed chute , there should be continuity unless the switch is pushed and clicked down. You can always give me a call tomorrow on 01789 400044 and option for Service. Or email me on [email protected] I can then send out a continuity test for the Bulgin plug which tests the operation of all the switches on the back end. Jase.

Good morning 😊 Yes it looks like a washout today....

Good morning Arbtalkers 😊 APF show for me today....

Good morning Arbtalkers and happy bloody Friday 😊 Doug , no idea what's on the stand , I'm going for a look tomorrow 😉