lamimartin

You are proving the point that Logosol M8 is NOT suitable for high volume production. There is no question that chainsaw woodmill is slower than a bandsaw. Getting a batch of blades to be sharpened at an affordable cost is certainly the way to go in both cases. High volume and chainsaw milling is not going in the same direction. I use my Logosol M8 to recycle the logs that I have fallen on my property and that I cut for special sizes and applications in small volume. I would never be able to match the production volume I get from a local woodmill that offers me standard size lumber to build my garage for instance. I would not have enough pines for such volume anyway.

I run a 20" for lighter weight when I don't need the 25 or 36" bar for falling or chopping large logs into firewood. I do 99% ripping on my Logosol M8 with the 25". I never use anything longer than the standard 16" bar on my MS261, in order to keep it as light and as powerfull as possible too. Low profile chains are substantially faster as ripping chain.

Welcome to the adventure of Logosol M8 ! I purchased a used one last year. It was barely used, packaged with a refurbished MS660. I must say I'm dealing with pines up to 60cm diameter and 4m long. This is really pushing the Logosol M8 to its designed limits. With such large logs, I don't think I could manage with less power. Fortunately, I've got a farm tractor with a loader and forks I use to carry the clean logs to the Logosol ramp. I carry several chains in my toolbox and I change them whenever the cut slows down. I sharpen chainsaw chains later in batches. Even if I could find an affordable bandsaw, I doubt I could do the sharpening myself. This keeps the cost of operation very low. In my humble opinion when high production volume is not a priority, Logosol M8 is an excellent tool. I'm a little surprised you have chosen a MS390, 64cc saw. Logosol recommends a minimal level of 90cc. I see it can use a bar up to 63cm, but it comes standard with a 50cm bar. I read you are planning to recycle hardwood logs into fine lumber. With a less powerfull saw, it will take even more more time per cut, especially on large diameter logs. It may be OK if you are mainly dealing with smaller logs (30-40 cm). I would advise you consider getting a set of bar compatible with narrow kerf chains which are saving wood and cutting faster than regular ripping chains.It will also leave a smoother finish, by far better than any bandsaw mill. The shorter your bar, the least power you need on the chainsaw. If you have enough of a 50cm bar for your logs, you could typically use Lo profile 1.3mm gauge picco ripping chain. It will really stretch the power of your little saw to the maximum. I personnaly replaced my log original log clamps with stronger ones (M8 LOG HOLDER XL) and I appreciate very much the big claw grip for the log end. I hope you have fun !