Jump to content

Log in or register to remove this advert

ride on will not start!


PeteB
 Share

Recommended Posts

  • 2 weeks later...

Log in or register to remove this advert

The grief goes on!

 

Took carb off, solenoid works and tube got a blow through. Valves appear to go up and down in the right sequence. Spark plug was wet and had a decent enough spark.

 

Is there a timing belt? How is the camshaft driven? It is almost as if the timing was out!

 

Any clues? The grass takes a lot of cutting with a walk behind!

Link to comment
Share on other sites

The grief goes on!

 

Took carb off, solenoid works and tube got a blow through. Valves appear to go up and down in the right sequence. Spark plug was wet and had a decent enough spark.

 

Is there a timing belt? How is the camshaft driven? It is almost as if the timing was out!

 

Any clues? The grass takes a lot of cutting with a walk behind!

If its an I/C engine it will be an old side valve, so no cambelt. The valves are driven by the camshaft and followers.

I reckon you have got a tight valve, so check the clearances in the first instance.

If that is not the problem have a look at the valves after taking the head off.

Link to comment
Share on other sites

Valves seem to go up and down the same amount and the valve springs etc seem to be in order.

 

It smells like petrol and isnt oily like diesel.

 

if it was a safety switch, there wouldn't be a spark.

 

Fuel filter cleaned, hoses checked. Choke works.

 

Occasional clunck from solenoid under tank and engine will not turn or turns slowly for maybe one cycle (as if battery weak or bad earth).

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.